04 Port Terminations





	\| Home \| About Us \| Products \| Installation Manual \| Contact Us \|





:: PORT TERMINATIONS ::
In this section of port terminations, we will guide the installer through the process of cutting cables and installing adapters to each cable, except the fiber (orange) cables. The estimated time of completion is 2 minutes per jack and 1 minute per F connector.

*NOTE: Click on each image to display a larger image or a sequence of images.

		A. Trim the Cables to Same Length
		- Use a wire cutting tool to trim the cables to the same length. The length should be 18 inches from the top of the media box


		B. Separate RG-6 Cables
		- Separate the RG-6 cables (black & white) with the wire stripping the tool


		C. Strip the Cables
		- Place the coaxial stripping tool close to the edge of the cable and spin the tool several times
		- Hint: The sharper the blade produces the cleanest strip


		D. Install F Connectors
		- After the cable is stripped, take a F connector and twist it tight into the cable
		- Tighten it with the compression tool


		E. Separate Telecom Cables
		- Strip the blue, green, and orange cables.


		F. Installing Keystone Jack
		- The wires came twisted, straighten it out with a stripping tool or something small that can grip the wire
		- Compare the color on the side of the keystone jack to the color of the wire, then press the wire in the slot
		- Use the 110 insertion tool to press the wires in place
		- Trim off the extra wires that sticks out on the sides
		- Put on the dust covers

		G. Testing Cables
		- The testing process requires two people to communicate with each through a communication device to check whether the cable connection PASS or FAIL


		H. Protect the Cables
		- Prevent dust and dirt from contacting with the cable connector, wrap a plastic bag over it and tighten it with a rubber band


		I. Last Step
		- Roll the cable(s) together and place it in the brackets.
		- Cover the opening with a metal plate and drill in the top and bottom screws


	TOP