05 Media Box Installations





	\| Home \| About Us \| Products \| Installation Manual \| Contact Us \|





:: MEDIA BOX INSTALLATIONS ::
In this section, we'll show you step by step to install the media box center. The estimated time for completing the media box is 6 hours and 1.5 minutes per face plate.

*NOTE: Click on each image to display a larger image or a sequence of images.
		1. SCRAPE AWAY
		- use a pallet to scape away paint that covered the outlet


		2. DRILL SCREWS
		- Take out the top and bottom screws with an electric drill or a screw-driver


		3. PULL OUT CABLE(S)
		- Pull the cable(s) out and unwrap the protective bag


		4. MATCH RING COLOR TO CABLE COLOR
		- The cable is black, so match the adapter ring color to it


		5. PUT ON ADAPTER
		- Take the adapter and push it into the cable then turn the adapter clockwise to tighten it


		6. SNAP CABLE TO FACEPLATE
		- Then snap it into a single gang faceplate


		7. PUSH CABLE BACK INTO OUTLET
		- Gently push the cable back into the outlet


		8. DRILL IN SCREWS
		- Drill in the top and bottom screws


		9. DONE WITH A SINGLE FACEPLATE
		- Tighten the screws and you're done


		10. INSTALLING MULTIPLE CUTOUT FACEPLATES
		- Perform steps 1 - 5 of how to take the cables out & attach an adapter to the white cable


		11. SNAP BOTH CABLES INTO FACEPLATE
		- Take 2 cutouts faceplate, and snap the white cable on top and the blue cable below


		12. PUSH CABLES BACK INTO OUTLET
		- Gently push the cables back into the outlet
		- Insert the top screw and drill it in half way
		- Then insert the bottom screw and drill it in half way


		13. DRILL IN TOP & BOTTOM SCREWS
		- Tighten the top and bottom screws


		14. FOUR CUTOUTS FACEPLATE INSTALLED
		- Perform the same procedures for 4 cutouts faceplate as if installing 1 or 2 cutouts faceplate


	TOP	>> Continue... \| PAGE 1 \| PAGE 2 \| PAGE 3 \| PAGE 4