| Home | About Us | Products | Installation Manual | Contact Us |
 
:: FINAL CONNECTIONS ::
In this section, we will guide the installer through the process of testing all cables to make sure they function properly.
Check back soon!
*NOTE: Click on each image to display a sequence of images.
  1. BEGIN TESTING
  - Take the tester RJ-45 cable and plug it into the specified   destination module pointed out by your partner
  - For an example: Your partner may specified to test the   master bathroom, living room, kitchen, etc.
 
     
  2. TESTER POWER ON
  - Switch the tester power on then communicate through   hand held device (walkie talkie) with your partner that   testing is ready
 
     
  3. TEST RJ45 CONNECTIONS
  - At the other end, your partner plugs the RJ-45 tester into   the wallplate
 
     
  4. TESTING RESULTS
  - The tester flashes GREEN, which means that the   connection functions properly
  - Continue to test other cables in all rooms
 
     
  5. TEST CONNECTIONS WITH FLUKE TESTER
  - Get some specific test data with the Fluke tester
  - Plug the cable tester into a specified location adapter (i.e.   living room, bathroom, dining room, etc.)
 
     
  6. POWER ON TESTER
  - Switch the Fluke tester power on and communicate with   your partner that the tester is ready
 
     
  7. TESTING
  - Your partner plugs the tester cable to the specified   adapter and begins the testing process
 
     
  8. FLUKE TEST RESULTS
  - In a couple of seconds the test results displays the final   results on the screen
  - If the screen displays : PASS
  - Then continue to test other cables
  - If the screen displays : FAIL
  - Fix the problem by replacing the connector
 
     
 
| Home | About Us | Products | Installation Manual | Contact Us |